![]() ![]() The short video below shows an LED being tested. ![]() Inductances of 0.01 mH to 20 H can be detected and measured. ATmega328P with 8MHz crystal ST7735 160x128px screen Rotary encoder 5.5mm x 2. Note that resolution is not equivalent to accuracy.Ĭapacitors in the range 35pF (picofarad) to 100mF (millifarad) can be measured with a resolution down to 1 pF. Resistors below 10 ohms will be measured with the ESR and a resolution of 0.01 ohm. WIDE APPLICATION: This multifunctional capacitance meter can be used to test triode, field-effect tube(FET), diode, resistor, capacitor, inductor, MOS, SCR, which is available for various electric transistor testing. The measurement range is up to 50 Mohm (Megaohm). Make sure this fits by entering your model number. Up to two resistors can be measured with a resolution down to 0.1 ohm. A protective circuit would probably also. It will measure hFE and base-emitter-voltage for bipolar junction transistors (e.g. It should be noted that the test inputs do not have a protective circuit. The unit will automatically detect NPN & PNP transistors, N- and P-channel MOSFETs, JFETs, diodes, small thyristors, and TRIACs. If you have surface mount components, you can use the pads on the PCB labelled 1, 2 and 3 instead of the DIL socket. I split the manual into the main section with the instructions and schematic, and a second section which contains transistor data, because the files are so. London Transistor Tester 1325 Equipment Cossor, A.C. The unit turns itself off after displaying the results for 10 seconds. Platino transistortester (130544 1) Elektor This simple Platino based Transistor Tester is designed to test transistors in a simple and portable way.Since it is tedious to read the markings on the transistor devices and to Transistor Tester 1325 Equipment Cossor, A.C. Just plug the component that you want to test into pins 1, 2 or 3 on either side of the DIL socket, then press the blue test button. The first trick is to make sure that you use a fresh 9V battery, if you don't then the display will be unreadable. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |